Cooper Menvier TS690ID Manual de usuario descargar pdf (Pagina 7)

WEBWAYONE LTD, Unit 11 Kingfisher Court

Hambridge Road, Newbury, Berkshire. RG14 5SJ

00 44 1635 231 514 support@webwayone.co.uk

Galaxy Ethernet Module Connections and Configuration – G2 – RS485

The WebWay SPT may be used where the Galaxy G2 running software is V1.4 or above. The SPT will emulate a

Honeywell Ethernet Module. SPT Emulation of an External Telecoms Module is not supported with the G2.

Connect the WebWay panel interface 485 A and B to the Galaxy connection terminals A and B– although the WebWay

needs to be on the data bus it is treated as with any other module so it can go anywhere on the bus chain. It must go on

Data Bus 1 however, Bus 2 is not supported. You will also need RTN connected to a GND in the panel.

Connect the WebWay PWR + and - to the GND and +12V terminals on the Galaxy Panel.

Galaxy Ethernet panel configuration

A lot of the Default Galaxy settings work fine for us. In the case of IP addresses, the WebWay SPT ignores the panel

settings so as not to be overwritten by the panel. This means that any valid IP address will do – our example is 127.0.0.1

Go to Menu 56

Select Ethernet Module (Menu 4)

Select Alarm reporting (Option 2)

Select Format (Option 1)

Enter SIA (Option 2), <Level 3(0-4)>

Press Enter

Under the trigger events settings you define which events the panel will report.

Note: it is recommended that the additional Triggers are selected:

Select 10 – Settings <ON> (Default OFF)

Select 18 – Zone Restorals <ON> (Default OFF)

Select Primary IP (Option 2)

Set IP Address <127.0.0.1> (blank by default)

Enter Port number <10001> (default)

Select Account number (Option 4)

Enter <_______> (Site ID)

Go to Remote Access (Option 3)

Select Access Period <Anytime>

Select Mode <Direct Access>

Select HW Priority (Option 6)

Select Ethernet <1(02)>

Select Telecom <0(02)>

Select Parameters (Menu 7)

Enter System ID < > (Site ID)

Use escape to return to Engineer Mode. You need to fully exit Engineering to find the WebWay as a Comms module, we

also emulate a Keypad, typically Comms Module 004 and Keypad 015 – varies between panels.

Back to panel list

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Sin comentarios

Cooper Menvier TS690ID Manual de usuario Pagina 7