Cooper Menvier TS690ID Manual de usuario Pagina 38

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 40
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 37
WEBWAYONE LTD, Unit 11 Kingfisher Court
Hambridge Road, Newbury, Berkshire. RG14 5SJ
00 44 1635 231 514 support@webwayone.co.uk
WebWay SPT Hardwired Pin Inputs
WebWay devices are shipped with 16 pin inputs available as a standard configuration. These can be used in conjunction
with any serial/DCM panel integration and used to send supplementary events such as Fire, Freezer, Smoke detection or
environmental alarms that are not normally connected via the Intruder System.
A full pins/hardwire only installation should be used as a last resort where full SIA and UDL capability is not possible (refer
to WebWayOne Panel integration for more detail).
When electrically connected the WebWay device is looking for a change of voltage on each individual pin. There is a hard
control to decide whether a POS (+12V) or a NEG (0V) BIAS is used to indicate change of state. In addition a
configuration profile is downloaded to the SPT and used to determine which state indicates an alarm or restore state.
For the hard control there are 2 settings that should be checked: Jumper J3 (just below the main display) is used to
control HIGH/LOW BIAS of pins 1-8. The control of HIGH/LOW BIAS for pins 9-16 is set using Dip Switch 8 (No 8 of
SW4). When set to HIGH BIAS the pins have a floating voltage and should be grounded (0V) to change state. They will
also change state when the 0V is lost. With LOW BIAS the pins sit at 0V and require +12V to change state.
Hard wired Inputs 1-16 configured as simple high inputs
Input threshold high to low 2.0V DC (maximum Input voltage: 30V DC)
If required the alarm and restore conditions may be reversed in the SPT configuration
Hard wired Inputs configured as simple low inputs
Input threshold low to high 4.0V DC (maximum Input voltage: 30V DC)
If required the alarm and restore conditions may be reversed in the SPT configuration
Hard wired PIN Inputs
PIN Input - Tamper configured as for simple low or high inputs
PIN Input - Battery fail configured as for simple low or high inputs
PIN Input - Mains fail configured as for simple low or high inputs
Vista de pagina 37
1 2 ... 33 34 35 36 37 38 39 40

Comentarios a estos manuales

Sin comentarios