WEBWAYONE LTD, Unit 11 Kingfisher Court
Hambridge Road, Newbury, Berkshire. RG14 5SJ
00 44 1635 231 514 support@webwayone.co.uk
10) Select DigiCom SIA Codes
1) Adding the ACM Module
Go into Installer Mode:
Press: [*] [7] [#]
Enter Installer or Grand Master code (or both as requested - depends on state of panel)
(Panel is now in Installation mode)
Menu Shows: "Engineer Prog" "1) System"
Press: [7] - to go to the Install Menu
Menu Shows: "Install" "Add/Del Module"
Press: [1] - to enter the Add/Del Module Menu
Menu Shows: "Add a Module" "Keypad"
Press: [9] - to select second selection of modules
Menu Shows: "Add a Module" "GSM"
Press: [3] - to select ACM
Press: [Part Set - to toggle selection
Menu Shows: "ACM Module" "Type=ACM1"
Press: [#] - to accept
Press: [*] repeatedly - to exit back to top menu
2) Set up the ACM Module – following on from 1)
Menu Shows: "Engineer Prog" "Install"
Press: [8] - to go to devices setup
Menu Shows: "Devices:" "ACM"
Press: [#] - to enter ACM setup
Menu Shows: "ACM" "ACM Params"
Press: [#] - to go into ACM Params
Menu Shows: "ACM Params" "ACM IP Addr"
Press: [#] - to set the ACM IP address
Menu Shows: "ACM IP Addr" "000.000.000.000"
Enter the IP address for the Communicator (or 127.000.000.001 to use DHCP) using arrow keys and digits
Press: [#] - to accept
Press: [Omit] - (down cursor) to go to subnet mask
Menu Shows: "ACM Params" "Subnet IP Msk"
Press: [#] - to change subnet mask
Menu Shows: "Subnet IP Mask" "255.255.255.000"
Enter the subnet mask for the Communicator using arrow keys and digits
Press: [#] - to accept
Press: [Omit] - (down cursor) to go to gateway IP
Menu Shows: "ACM Params" "Gateway IP"
Press: [#] - to change gateway IP
Menu Shows: "Gateway IP Addr" "000.000.000.000"
Enter the IP Address for the local network's default gateway/router (or 127.000.000.001 to use DHCP) using arrow keys
and digits
Press: [#] - to accept
Press: [Omit] - (down cursor) to go to gateway IP
Press: [*] repeatedly - to exit back to top menu
3) Set up the Communication Path IP Addresses and Port numbers – following on from 2)
Menu Shows: "Engineer Prog." "Devices:"
Press: [5] - to enter DigiCom setup
Menu Shows: "Digicom" "Link up"
Press: [#] - to Enter Digicom Link-up
Menu Shows: "Link-Up" "ARC Link-Up"
Press: [#] - to Enter ARC Link-Up
Menu Shows: "ARC Link-Up" "ARC 1 Link-Up"
Press: [#] - to Enter ARC 1 Link-Up
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales