Cooper Menvier SD3 Especificaciones descargar pdf (Pagina 17)

Programming SD1+

Option 2: Recording Messages

The SD1+ can transmit up to four messages. A message

is made up of two phrases: phrase 0 plus one of phrases

A, B, C or D. Each trigger (A, B, C or D) is linked to one

of the phrases A, B, C or D.

Normally you should use phrase 0 to store the name and

address of the premises. Use phrases A to D to store a

short name for the condition triggering them (for example

“Alarm” or “Fire”).

It is also advisable to include the instruction “Press 8 to

acknowledge” at the end of each of phrases A to D. For

example:

Phrase 0: “This is Mr Smith, at 10 The Strand, East

Fincham.”

Phrase A: “The alarm has been activated. Please press

8 after the beep to acknowledge this call.”

Before you record the phrases it is a good idea to write

down what you intend to say.

Note that the SD1+ can hold up to 25 seconds of sound

for each phrases.

To record a phrase:

1. If necessary initialise the SD1+ .

SD1+

2. Key in the current passcode.

READY

3. Press 2. The display shows “ENT 0-D”.

ENT 0-D

4. Press 0, A, B, C or D to select the phrase you

want to record. The display shows the word

“RECORD” alternating with the word “PHRASE” and

the phrase letter, for example:

RECORD

PHRASE A

5. Press [. SD1+ starts recording.

Speak clearly.

Stand about 15 to 20 centimetres from the unit.

REC - 39

SD1+ Programming

number (or correct any other digit).

6. Press [ to store the new telephone number and

return to “ENT 1-4”.

At this point you can select any phone number by

pressing keys 1, 2, 3 or 4.

ENT 1-4

7. Press [ again to return to “READY”.

READY

To comply with BABT regulations do NOT program any two

telephone numbers to be the same.

Do NOT program the SD1+ to call the Police using the Emergency

Services telephone numbers.

PROGRAMMING PAGER MESSAGES

When dialling a pager the SD1+ may have to wait before

sending the message. To insert a pause enter “M” after

the pager number. When the paging equipment answers

the call, the SD1+ can send the message as normal, or

precede it with a “star” or “hash”. The SD1+ always

terminates a pager message with a “hash”.

Each pager service has its own requirements for pauses,

star and hash. You may have to experiment to find the

correct combination for the service you are using.

1. If necessary initialise the SD1+ .

SD1+

2. Key in the current passcode.

READY

3. Press 1.

ENT 1-4

4. Press 1, 2, 3 or 4 to select telephone number

1, 2, 3 or 4. The display shows “TEL NO “ alternating

with the digits stored, for example:

If you wish to erase all the digits stored for that

number press A.

The screen shows “BLANK” if the SD1+ does not

have any digits stored for a number.

TEL NO 2

9012334

1 2 ... 12 13 14 15 16 17 18

Comentarios a estos manuales

Sin comentarios

Cooper Menvier SD3 Especificaciones Pagina 17

Comentarios a estos manuales