Cooper Menvier SD3 Manual del operador descargar pdf (Pagina 25)

answer the incoming call and allow the caller to use the ‘remote access

feature’, see page 48.

If disabled (OFF) the SD2 will answer all incoming calls after the number of

rings programmed for the Ring Count, see option below.

Flash On Message:

If enabled (ON) the SD2 will flash the display backlight on and off when

message is waiting (default). Listening to the message cancels the display

flashing.

If disabled (OFF) the SD2 will not flash the display backlight.

Beep On Message:

If enabled (ON) the SD2 will beep every minute when message is waiting.

Listening to the message cancels the beep.

If disabled (OFF) the SD2 will not beep (default).

Auto Record:

If enabled (ON) the SD2 will automatically switch the microphone on and

start recording for up to 30 seconds when any trigger input is present. The

recording is then stored in the ‘Memo feature‘. Playing back the recording

can then be either accessed using the remote access feature (see page 49)

or via the memo playback feature via the keypad (see page 46).

If disabled (OFF) the SD2 will not automatically record a message

(default).

Temperature High:

This option allows you to set the temperature at which the temperature

high output will activate (see “Output Options” on page 30 ). Working

range of 0°C to 50°C (default 40°C).

Temperature Low:

This option allows you to set the temperature at which the temperature low

output will activate (see “Output Options” on page 30). Working range of

0°C to 50°C (default 5°C).

Temp Display:

If enabled (ON) the SD2’s display will show the current ambient

temperature in degrees centigrade, (default).

If disabled (OFF) the SD2’s display will not show the ambient temperature.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Sin comentarios

Cooper Menvier SD3 Manual del operador Pagina 25